D-SUB connector - VS-09-PROFIBUS-SC - 1654549
- Produttore:
- PHOENIX CONTACT
D-SUB connector, degree of protection: IP67, number of positions: 9, material: PA, connection method: Screw connection, connection cross section: AWG 26- 16, cable outlet: Angled, with integrated termination resistor, size of housing: 1, color: gray
Features
EMC protection
Switchable terminator
Coding sections (CR) as protection against mismatching
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.
WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
The products are suitable for applications in plant, controller, and electrical device engineering.
When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
Assembled products may not be manipulated or improperly opened.
Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
When using the product in direct connection with third-party manufacturers, the user is responsible.
For operating voltages > 50 V AC, conductive connector housings must be grounded
Only use tools recommended by Phoenix Contact
The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
Use a protective cap to protect connectors that are not in use.
Operate the connector only when it is fully plugged in and interlocked.
Operate the connector only when it is fully plugged in.
Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
Observe the minimum bending radius of the cable. Lay the cable without twisting it.
VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
EAC
Specifications
Height | 59 mm |
---|---|
Length | 107 mm |
Width | 24 mm |
Environmental Product Compliance | |
REACh SVHC | Lead 7439-92-1 |
China RoHS | Environmentally Friendly Use Period = 50 years |
China RoHS | For details about hazardous substances go to tab 'Downloads', Category 'Manufacturer's declaration' |
Material data | |
Housing material | PA |
Housing surface material | PA, light gray |
Width | 24 mm |
Height | 59 mm |
Length | 107 mm |
Mechanical characteristics | |
Connection method | Screw connection |
Cable outlet | Angled |
No. of cable outlets | 2 |
Conductor cross section | 0.14 mm² - 1.5 mm² (solid) |
Conductor cross section | 0.14 mm² - 1 mm² (flexible) |
Weight | 93.5 g |
Minimum external conductor diameter | 5 mm |
Maximum external conductor diameter | 9 mm |
Overvoltage category | II |
AWG solid min. | 26 |
AWG solid max. | 16 |
AWG multi-stranded min. | 26 |
AWG multi-stranded max. | 18 |
Degree of pollution | 2 |
Electrical characteristics | |
Number of positions | 9 |
Rated current | 1 A |
Overvoltage category | II |
Degree of pollution | 2 |
Rated voltage (III/3) | 50 V |
Ambient conditions | |
Ambient temperature (operation) | -20 °C - 75 °C |
Degree of protection | IP67 |
Standards and Regulations | |
Flammability rating according to UL 94 | V0 |